Jump to content

MobileJoy

Members
  • Posts

    121
  • Joined

  • Last visited

  • Days Won

    1

MobileJoy last won the day on September 20 2023

MobileJoy had the most liked content!

My Info

  • Gender or Couple
    Couple

My RV or Travel Trailer

  • Do you own an Oliver Travel Trailer, other travel trailer or none?
    I own an Oliver Travel Trailer
  • Hull #
    850
  • Year
    2021
  • Make
    Oliver
  • Model
    Legacy Elite II
  • Floor Plan
    Twin Bed Floor Plan

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

MobileJoy's Achievements

Collaborator

Collaborator (7/14)

  • Very Popular Rare
  • One Year In
  • Reacting Well Rare
  • Collaborator Rare
  • Conversation Starter

Recent Badges

253

Reputation

  1. Oliver's website now has a Travel Trailers / Find a Dealer page where you enter your address and a search radius.
  2. I also have the 390Ah Lithionics and 340w solar system. This week I took Mojo out of storage. Batteries were at 100% because I keep them charged. Since it was time to do a full discharge cycle, I turned on the Norcold fridge on DC mode. The fridge was not pre-cooled, and the temperature inside Mojo was 60 degrees. Solar conditions were not good. The batteries entered LBCO in just under 1 day. In addition, I had the heater running (set at 65 degrees) so the blower was also operating, as was the Xantrex inverter. Not an apples-to-apples comparison with your situation. Usually, I use DC mode only when traveling, and I observe 5-10% drain from fully charged batteries depending on trip duration, outside temperature, and sun exposure. I haven't tried to gauge this accurately. Regarding low battery cutoff, this is done individually as each battery reaches 12.1V. When there is power draw, voltage tends to be lower, so the batteries can cut off before they get down to 10% of charge. In this case, the batteries did cut off at about 13% of charge.
  3. I have a 30A male to 15A female connector along with a home outlet circuit tester. These testers are much cheaper than the 30A tester, and I already had one. This allows me to check proper wiring at the 30A outlet in the pedestal before plugging in the trailer. In theory the inboard EMS does these tests, but why plug in if you already know the pole is incorrectly wired? I do not use an external EMS/protector.
  4. Congratulations on your purchase, fellow NC'er! I'm sure you will enjoy your Oliver as much as we do ours. Reading the comments above, it looks to me like contributors are thinking that the trailer overloaded the circuit, yet you describe tripping a ground fault circuit interruptor. I have an adapter that converts from the 30A connection to a regular 20A cord. In my driveway, I used this adapter with the proper gauge extension cord many times without a problem. Then one time I came home and hooked it up, and as soon as the energy management system (EMS) cut in the power to the RV the 20A GFCI in my garage tripped. I opened a ticket reporting this ground fault, and the short story is that it was recommended to me that I have a 30A circuit installed. Before I could do that, I removed the GFCI and replaced it with a regular 20A outlet. After that the problem went away and I was able to recharge my batteries with the Xantrex. Note the EMS takes some time to turn the power on to the trailer, so this could have been responsible for the delay you experienced. I never tried changing the #28 setting on the inverter (i.e., 25A to 15A). I don't see what that could have to do with a ground fault (anyone care to explain), but it's worth a try. Ultimately I did install a 30A circuit at home and have not had a problem since. I also have trailer storage with a shared 20A circuit. With multiple bays using it, you have to limit the amount of current that you draw. I use a separate 20A charger that I connect directly to the batteries so the Xantrex is not seeing power.
  5. Monitor your power source. You can do this easily by looking at the EMS panel. In our Oliver the panel is in the attic and its readout is in red LEDS. If the voltage drops to around 104V, the EMS will cut off shore power. If the Xantrex is drawing a lot of power (as it will by default when charging your batteries), with an unstable shore power source this could bring down the voltage to the point of EMS shutdown. This removes the power drain and allows the voltage to rise. Once it is sufficient, the EMS cuts back in and eventually powers the Xantrex. The resulting battery charging draw will bring down the voltage, etc., etc. I had this happen to our trailer at a campground that had unstable 30A shore power. Even if your batteries are fully charged, the Xantrex starts off by attempting a full charge and then rapidly changes from Bulk charging to the Absorption stage which draws much less power. You can also reconfigure the Xantrex to charge batteries at a much slower rate so its power draw is not so severe. May help, may not... We have the Lithium Pro package and Xantrex charging is set by default to 150A.
  6. Welcome to the Oliver community! It appears that your intent is to boondocks quite a bit since you are opting for the Lithium batteries. Have you considered the composting toilet? There are many threads on this, but it is one of those things where you either love it or hate it. In our case, it's the former. It expands the time we can spend without sewage hookup allowing us to either boondock or enjoy partial hookup campgrounds. It is more work than a flush toilet, but I feel it's worth it. Airstream was our first choice. We were considering a medium size (25'-27') when I noticed a very small ad in a sidebar of one of the news sites I read for Oliver. That sent us to their website, and almost immediately changed our direction. Our camping goal was to bring home with us as we traveled the country. We have tenting experience but no previous experience with RVs, although I am a homeowner / engineer with some experience in carpentry, electrical, and plumbing so the thought of maintaining a second home didn't bother me. We made the trip to the mother ship for a factory tour. That trip sold my wife on Oliver. She loved the bright interior and decided that living in an OEII would work for her. We had at that point been inside many travel trailers. Thus far, we have done about 16K miles traveling. We have used the service ticket many times. This has been fantastic. The OEII has been pretty reliable. The downsides of it for us are the few things that require frequent maintenance such as the need to lube the chassis every 3,000 miles and to constantly inspect the window tracks to ensure proper drainage. Other things that require maintenance and inspection are done less frequently. Many of these are discussed on this forum (such as checking the torque on bolts that hold the stabilizer jacks in place, servicing wheel bearings, etc.). I can do most of these things myself, but I still do an annual visit to the mother ship for maintenance. Regarding the small size, we are comfortable with this. We can get by each other with no difficulty. Using the wet bath is no problem for us since we are well under 6' tall. We have so far stayed in it up to 9 weeks consecutively and never felt constrained even on rainy days. We did endure a heavy 10 minute hailstorm which dented our truck hood but did no damage at all to the OEII or its solar panels. I'll bet there would have been dents in our Airstream! Otherwise, I can only echo the advice given above. I believe you will love it! The level of service they offer, this Forum, their Facebook page, and the Oliver University are awesome.
  7. Ah, so the AC from the inverter is physically connected to the ATS. Looking at the manual, the AC output of the ProWatt is a built-in GFCI outlet. So is the connection a grounded plug attached to a Romex cable at the inverter end?
  8. Can you tell me how the PROWatt is connected to the AC outlets and accessories? Perhaps a photo? Thanks.
  9. I generally agree with this statement. However, if you are storing your OEII, leaving the batteries installed, turning on the heating pads, and connecting an external charger to prevent depletion, then you have to leave the batteries on. In that case, a master cutoff switch would shut down all parasitic draws in the OEII. As Geronimo John pointed out in a different thread, a small propane leak and leaving the tanks turned on during storage could lead to propane pooling and possible ignition, so having the interior devices turned off is an additional safety precaution. If you store by depleting charge to 50% and turning off the batteries then there should be no need for a master switch.
  10. Of the two inverters discussed above, I prefer the Freedom series. This one can be programmed for most battery types, and it performs automatic switching to your AC circuitry between inverted power and shore power. It is designed to be wired to your AC system where the PROWatt provides AC outlets instead. In your case, there must already be a battery charger in your trailer. Many contributors on the Forum have said that they don't like the combined inverter/charger (Xantrex Freedom) and would have preferred these to be separate to eliminate a single point of failure. You can probably find an inverter that can be wired into your AC system and that does not charge the batteries. Unless your previous owner upgraded, based on your model year you do not have LiFeBlue or Lithionics batteries. I think Oliver started offering Lithium batteries in 2020. A quick look will tell you what you have. If you have the standard lead-acid batteries, an inverter won't provide significant power for very long. You should choose the inverter based on your upgrade intentions. If you are going to install LiFePO4 batteries (many on the Forum have installed BattleBorn) then get a 3000 watt model, otherwise a 2000 watt model is sufficient. Your AC may or may not have the soft-start capacitor which may be necessary when running on inverted power. I agree. Figure out what you want and then open a ticket with your questions.
  11. In case you don't have the PROWatt, the Freedom inverter looks like this. Note it has a control panel. This is a large box that will likely be mounted under the street side bed near the pantry.
  12. The PROWatt inverter itself looks like this:
  13. Oliver University. It is from the 2018 Xantrex PROwatt 2000 Inverter Remote Manual.
  14. If you don't see the Freedom panel, see if there is a PROWatt panel like this one. I got this from the 2018 model. I couldn't identify the one used for 2019 specifically.
×
×
  • Create New...