Corcomi 0 Posted December 16, 2018 This morning I went to check up on Ollie and found that it didn’t have electricity. After checking everything I found that the electric gfi under the dinette had tripped. So all is well on that end. But when I went to put on the furnace heat to warm the trailer both the furnace and electric strip turned on. I have the controller on furnace heat. Tried turning on and off but still get both to turn on. Any suggestions ? Share this post Link to post Share on other sites
John E Davies 23 Posted December 16, 2018 Sounds like a thermostat problem, that is the only common point in the wiring of the two systems as far as I know. Can you just pull the circuit breaker for the AC for now? If that doesn't do it, take the 'stat off the wall and disconnect the low voltage wires for the heat strip. Tape them so they can't short out. Refer to your manual for the diagram. I don't have this setup.... "Mouse" has a 1950s style mercury thermostat for the furnace and no heat strip. Crude, but 100% reliable. Good luck. John Davies Spokane WA 1 "Mouse": 2017 Legacy Elite II NARV (Not An RV) Two Beds, Hull Number 218, See my HOW TO threads: https://olivertraveltrailers.com/topic/john-e-davies-how-to-threads-and-tech-articles-links/ Tow Vehicle: 2013 Land Cruiser 200, 33" LT tires, airbags. Share this post Link to post Share on other sites
ScubaRx 11 Posted December 16, 2018 Your system is preforming normally, no need to unhook anything. Change your fan off "auto" and it will work as expected. 3 Steve, Tali and the dogs: Reacher, Lucy and Rocky plus our beloved Storm and Maggie (both waiting at the Rainbow Bridge) 2008 Legacy Elite I - Outlaw Oliver, HULL NUMBER: 0026 2014 Legacy Elite II - Outlaw Oliver, HULL NUMBER: 0050 2017 Silverado High Country 2500HD Diesel 4x4 Share this post Link to post Share on other sites
Mainiac 0 Posted December 16, 2018 As ScubaRX stated... I have had that happen to me. Don't know how it happened. But setting it to 'Auto' and we were back to normal. 1 Share this post Link to post Share on other sites
GeauxSouth 0 Posted December 16, 2018 This should be normal. It has also been discussed before (do a search for Furnace/Heat Strip). You didn't mention which a/c unit or thermostat that you have, but I think that they all work alike. If "my" thermostat is set to "electric heat" and there is more than a 5 or 6 degree difference in the set temp and the room temp, then the gas and the electric heat will run. After the room temp nears the set temp setting it will shut the gas furnace off and continue on electric heat until the set temp is reached. This is because the electric heat is more of a maintainer. The electric heat would take considerable time to heat the RV on its own. Hope that this helps. Shirley 3 Shirley Arrighi Share this post Link to post Share on other sites
Corcomi 0 Posted December 17, 2018 Thanks to all who posted. I did put it back to auto and it went back to normal operation ?? 2 Share this post Link to post Share on other sites