Jump to content

Extra parts - Not


Recommended Posts

While considering to replace my grey tank seal, I found a lose spare part, a pex fitting end/stop. LOL. Been there's likely since 2016. Not something I want rolling around with electrical connections. Does have a brass crimper and the brass connector. 

Also finger-checked all my electrical connections under the driver's side bed to ensure everything is still snug. 

 

PXL_20230513_123454097.jpg

PXL_20230513_124040651.jpg

  • Wow 2
  • Sad 1

Chris
2016 Legacy Elite II  o--o  Hull #110 o--o  Wayfinder  o--o  Twin Bed  o--o  2020 RAM 1500 Limited 5.7L 
Augusta, Georgia

Link to comment
Share on other sites

20 minutes ago, Wayfinder said:

grey tank seal

Was it easy to replace that grey tank seal/gate valve?

2023 Elite II, Hull# 1386, Lithium Platinum Package (640AH, 400W Solar, 3000W Xantrex Inverter)
Truma water heater & AC

TV: 2024 Silverado 2500HD 6.6L 10-Speed Allison

Link to comment
Share on other sites

10 minutes ago, rich.dev said:

Was it easy to replace that grey tank seal/gate valve?

Funny you should ask. Still trying. The bottom bolts are right on the basement floor. TIGHT, very!  

No curse words yet, but no promises. I tried to shim under the pipe, but man it would budge. So, slow going with big man fingers. 

PXL_20230513_131305179~2.jpg

  • Like 2
  • Wow 1

Chris
2016 Legacy Elite II  o--o  Hull #110 o--o  Wayfinder  o--o  Twin Bed  o--o  2020 RAM 1500 Limited 5.7L 
Augusta, Georgia

Link to comment
Share on other sites

I hope Oliver lifts this up off the floor even 1/4". He'll, I'd be happy with 1/8". 

Chris
2016 Legacy Elite II  o--o  Hull #110 o--o  Wayfinder  o--o  Twin Bed  o--o  2020 RAM 1500 Limited 5.7L 
Augusta, Georgia

Link to comment
Share on other sites

11 minutes ago, Wayfinder said:

So, slow going with big man fingers

Haha feel your pain, I also have sausage fingers! 

  • Haha 1

2023 Elite II, Hull# 1386, Lithium Platinum Package (640AH, 400W Solar, 3000W Xantrex Inverter)
Truma water heater & AC

TV: 2024 Silverado 2500HD 6.6L 10-Speed Allison

Link to comment
Share on other sites

13 hours ago, rich.dev said:

Was it easy to replace that grey tank seal/gate valve?

NOOOOOOOO, no it was not easy. LoL 

OMG that was two hours I'll never get back. It's done and with no leaks. I filled up the grey tank to 100%, and then some. I let it sit for over an hour, checking for leaks very carefully and with a very bright light and white glove test. I also opened and closed the gate valve a few times and checked for leaks.  

The grey tank valve in this 2016 model is extremely difficult to do. Unlike the black tank valve that has rubber pipe connectors to loosen up for wiggle room. 

Next time, I drive to Tennessee and let Oliver curse through that grey tank valve. Errrgggggg. 

If you have a bad back, are over weight, or have arthritis in the hands I would think twice before attempting this.  I hope the newer models have improved this part replacement. I had to rest my head on the jack motor several times. Oh, long arms are required. 

I've annotated some pictures. No certain order. Hopefully the plumbers grease will add an extra two years of life. 

I think the job could have been substantially easier if the gate valve could have been 1/8 to 1/4 inches off the basement floor.  It would have at least saved time getting the two lower nuts off and on again.  It's tricky for sure.

I'm considering doing a short video with the pics and doing a voice-over to describe the challenges.

In some of the pictures you can see what I believe is the grey tank sensor board in the background.  Be careful with tools around the sensor, it could be damaged and work even less affective than it already does.

I used a hammer as leverage to separate the grey tank side of the valve with the main black tank pipe.  On my TT many of the electrical wire bundles were between the hull and the main drain pipe, preventing movement.  I was however able to lift the bundles up to relieve some of the pressure on the drain pipe.

PXL_20230513_132232354.MP~3.jpg

PXL_20230513_134710276~3.jpg

PXL_20230513_135019282.MP~3.jpg

PXL_20230513_135239399~2.jpg

PXL_20230513_154924679~2.jpg

PXL_20230513_154959857~2.jpg

PXL_20230513_134630132~2.jpg

PXL_20230513_134755227~2.jpg

PXL_20230513_135041477~2.jpg

PXL_20230513_135520532~2.jpg

PXL_20230513_140038368~2.jpg

PXL_20230513_140256591~2.jpg

PXL_20230513_141548670~2.jpg

PXL_20230513_131305179~2.jpg

PXL_20230513_124040651.jpg

 

  • Thanks 2
  • Like 8

Chris
2016 Legacy Elite II  o--o  Hull #110 o--o  Wayfinder  o--o  Twin Bed  o--o  2020 RAM 1500 Limited 5.7L 
Augusta, Georgia

Link to comment
Share on other sites

  • Moderator+
3 hours ago, rideandfly said:

When replacing the black tank valve, used a piece of double sided tape to hold the nut while threading into it:

i-KBBQNsn-L.jpg

 

That's cheating...

  • Like 3
  • Haha 1

Steve, Tali and our dog Rocky plus our beloved Storm, Maggie, Lucy and Reacher (all waiting at the Rainbow Bridge)

2008 Legacy Elite I - Outlaw Oliver, Hull #026 | 2014 Legacy Elite II - Outlaw Oliver, Hull #050 | 2022 Silverado High Country 3500HD SRW Diesel 4x4 

 

             801469912_StatesVisitedTaliandSteve08-23-2021-I.jpg.26814499292ab76ee55b889b69ad3ef0.jpg1226003278_StatesVisitedTaliandSteve08-23-2021-H.jpg.dc46129cb4967a7fd2531b16699e9e45.jpg

 

 

Link to comment
Share on other sites

7 hours ago, ScubaRx said:

That's cheating...

If ya ain't cheat'n - ya ain't try'n!!!

  • Like 1
  • Haha 1

spacer.png

Art, Diane, Oscar & Magnus (double-Aaarrf!)

  • 2022 TUNDRA w/Airlift Load Lifter 5000 kit/2017 LE II; Hull #226 "Casablanca", 12VDC Starlink kit, 3x Battle Borns; Victron Cerbo GX, SmartShunt, MPPT Solar Controller, & DC-DC Charger; HAM call-sign:  W0ABX
Link to comment
Share on other sites

  • 2 weeks later...
On 5/13/2023 at 8:53 PM, rideandfly said:

When replacing the black tank valve, used a piece of double sided tape to hold the nut while threading into it:

i-KBBQNsn-L.jpg

 

That’s wisdom! Learned this sticky trick years ago. Great to see it still being used. Thanks @rideandfly!

 

  • Like 3

 

2020 OLEII - Hull #634 aka-  “XPLOR” 

2021 F350 6.7 liter Diesel Lariat Ultimate Tremor aka- Beast

 

IMG_2879.jpeg

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...