rideandfly
-
Posts
1,871 -
Joined
-
Last visited
-
Days Won
65
Posts posted by rideandfly
-
-
Mike,
Nice photos! Appreciate the SP report!
-
1
-
-
Malcolm and Ursula,
Agree, we really enjoying camping with our Ollie, too. The folks at Oliver been great to work with. We showed the Ollie several times during the last camping trip and probably over 100 times at campgrounds since buying it used last year!
-
2
-
-
Tom & Cheryl,
Welcome!
We did not know how the Ollie's twin bed was going to work out for us, but it has worked out nicely. We really like camping with the Ollie!
-
Hope to have a photo from Tellico Plains TN. Campground has two RV sites with 7 very small log cabins and many tent sites. The owner believes 300 people may gather there. Edit: Have not been boondocking with the Ollie so far, but will give it a try during the next year.
NASA Eclipse Videos:
-
2
-
-
Clair & Kathy,
Congrats on "Clever Beast"!!!! Look forward to seeing photos, too!
-
1
-
-
Marsha,
We had the same problem about a year ago. Removed most of the old tape and used 2" wide aluminum foil tape (with adhesive on one side) to replace the original tape. Purchased the tape at a local Lowes hardware store where we were camping. Took about 1 to 2 hours to replace the tape at the campsite, used scissors to trim many pieces of tape to fit. I don't remember if aluminum tape was made by 3M or Scotch. Overlapped many pieces of tape to support the weight of the curved aluminum plate.
Edit: If I had been at home where I have cleaners/solvents available, would have prepared originally taped areas with compatible cleaner/solvent for better adhesion of the tape considering the weight of the aluminum plate and heat from the refrigerator. Initially this was supposed to be a temporary fix until returning home from the camping trip. After finishing the repair, it looked good and been in service for over a year.
Normally use a label & sticker remover (Turtle Wax) to remove old adhesive and clean with alcohol before applying an adhesive. Check aluminum foil tape label/instructions to be sure alcohol can be used. Aluminum tape instructions/specifications can also be found on the manufacturers website.
Hope this helps!
Aluminum foil tape installed after one year of use:
-
Bill, We had so much fun with you and Debbie. Thanks for being a terrific tour guide.
David,
We enjoyed meeting and spending time with y'all, too! The eclipse glasses are on order!
-
Appreciate the great tips on how to make better coffee!!!!!
Thanks Everyone!
-
Angela and Kyle,
Welcome and congratulations on your Ollie!
We also like camping at TN State Parks. The fall foliage in TN may be nice when you pick up your Ollie, too.
This event is too early for your Ollie pick-up date, but we want to attend the National Banana Pudding Festival at least one time in the future. It will be held 10/7 & 8 this year at Centerville, TN.
-
1
-
-
Purchased a "Coleman Camping Coffeemaker" drip coffee maker and used it during the last two camping trips. Turned the flame down low on an old 2 burner propane camp stove. It took 3 times longer to brew the coffee at a low flame setting compared to our electric drip coffee maker in the camper & home using same coffee and water. If we poured a cup before the complete pot brewed, the coffee was strong. If we waited for the complete pot to brew, it was very good! Purchased a Coleman stainless steel coffee pot to replace the original glass pot and Coleman carry case.
-
Since the forecast was warm and humid this weekend, we headed back to Mount Pisgah Campground NC on the Blue Ridge Parkway to get out of the heat. Had the pleasure to meet another forum member. Hiked to Crabtree Falls NC close to BRP, too!
Mr. Trumpetguy:
Crabtree Falls NC close to BRP:
-
3
-
-
The previous Ollie owner had built two light weight rear jack blocks with foam block encased with wood then wrapped with fiberglass cloth. He was also a fiberglass airplane builder. Use these to stabilize with rear jacks, but did not have room with the curb. Had to back the Ollie almost to the curb to keep the hitch from protruding out in the road.
Will check out Tractor Supply for thin jack material, good tip!
Really like these light weight jack blocks, too:
-
Also reading discussions on Air Forums.
Folks there are starting to replace lead/acid batteries with Battle Born BB10012 Lithium Ion LiFePO4 Battery 12V 100Ah batteries with built in battery management system.
Contacted Battle Born about using the 100watt Renogy Portable Suitcase Solar Panel system to charge the Battle Born batteries. They said the Viewstar VS1024BN controller's settings are not compatible with their batteries. Working to resolve this issue.
We have an original equipment Progressive Dynamics PD4045 power control in our 2015 Ollie. After reading Battle Born site information, the existing power control will charge Battle Born batteries, but for faster charges the 14.4V boost mode would charge faster. After talking to Progressive Dynamics, my power control boost mode comes on when battery voltage drops to 12V or every 21 hours for 15 minutes to prevent battery stratification.
Could replace the existing PD 4045 convertor section, located above the fan in existing power control, with a Progressive Dynamics # PD4045LICSV convertor section, for Lithium battery charging. The folks at solar-electric.com said to give the original Progressive Dynamics charger a try first, it may work fine without upgrading the convertor section.
-
1
-
-
Here's using 2X6 on the low side. Going to cut shorter 2X6 planks to place under the rear jacks when backed over a curb. Jack blocks normally used were too tall to fit between the jack pads and curb:
-
2
-
-
Pete & "Bosker",
Beautiful Shot!!!!
-
Mike, Hope you don't mind this photo from an Ollie camping trip last August.
Bill: We love camping along the entire Blue Ridge Parkway, this is one of our return to locations many time over the past years. In the fall we try to spend a couple of weeks on the BRP in various campgrounds.Horace & Dianne,
Debbie and I plan to camp on the BRP, probably Mount Pisgah, during August, too. Hope to go for a motorcycle ride on the BRP later this week. Hopefully will meet y'all while camping on the BRP!
Took this shot on the BRP in VA during a Ollie camping trip last year:
Mabry Mill VA:
-
4
-
-
Jason,
I don't have a Facebook account, but will check out Oliver on Facebook!
Thanks!
Bill
-
rideandfly – I love your photos! May I use one on our facebook? We are ALWAYS looking for great high resolution photos that we can post! GREAT SHOTS and thank you for sharing with us! – Jason
Jason,
Please use any of my photos you want, the photos posted are reduced resolution, but happy to forward any full resolution shots you may want.
The evening before heading to Mount Pisgah, found what is really at the end of the rainbow:
Thanks,
Bill
-
5
-
-
Mike, Thanks!
Trumpetguy likes to camp on the BRP, too. We camp and ride motorcycles around Grandfather Mountain, Linville Falls, and Pineola NC. The temps were from the low 60s to mid 70s, no need for AC or heat.
-
Just returned home from camping on the Blue Ridge Parkway at Mount Pisgah NC. We like to camp there when it gets warm and humid in the lower elevations. Warm and humid here at home, so need to head back to the BRP soon!
Mount Pisgah Campground:
Overlook on BRP:
Skinny Dip Falls, short hike from BRP milepost 417:
Moore Cove Falls, short hike from Rt. 276:
-
4
-
-
Congratulations on your new Ollie!
Enjoyed the seeing all of the fine camping photos and Hank! Hopefully will meet y'all camping in the future!
-
1
-
-
Larry,
Thanks for the article. Coffee is an important part of our camping, too. Our Son has been telling us about cold brewing Coffee, so we may give it a try. It's good cold or hot.
-
1
-
-
GrayGhost,
Great trip and beautiful photos! Appreciate the heads-up on the loose tire cover nut, too. Your Ram gets excellent fuel economy!
-
1
-
-
Overland, Thanks for starting this thread!
I started the generator again today but just to top it off. The Renogy Solar Suitcase is holding it steady, next I will be turning off the Zamp system and seeing how far I can push the 100watt Renogy system.
We don't have factory installed solar panels on our Ollie.
We have a 100watt Renogy Suitcase Solar Panel system and just purchased a Honda EU2000i. Most of the time we camp at campgrounds with shore power, but in the summer we camp on the Blue Ridge Parkway to get out of the heat in the lower elevations. Federal sites on the BRP do not have electricity, so we use the Renogy system to maintain two 27 series 12V batteries (stock from OTT) and going to try out the Gen-Set when parked on shady sites to charge batteries.
Will be camping on the BRP later this month, will post how this system works out.
Edit:
Did some additional research on EU2000i and OTT installed Progressive Dynamics power system specifications that answered questions I had.
Will research installing a Victron battery system to replace the 27 series 12V batteries when they need to be replaced. Trumpetguy mentioned using the Victron battery system, too. Used his idea for the MicroAir EasyStart 364 for AC operation with the EU2000i.
SUV's pulling Elite II's?
in Towing an Oliver
Posted
Joe,
Nice looking rig! Your F-150 makes a fine TV for the Ollie! Like the colors, too!