Cielo Breez Max

[Treasure Coast Vault]

I went ahead and started a thread for this Smart Thermostat. I just installed it for my Pioneer Inverter and it works like a charm. Fan shuts down with the compressor. A wonderful little gadget. Thank you folks for showing us this.

All I did was use the USB port in the Ollie for power and it was a "Breez" to get connected. Thanks for schooling us on the comfort modes too.

 

[rich.dev]

Great thanks, can an admin please transfer the relevant posts from the Dreiha Atmos thread that I believe started around here to this thread, thanks! 

[Ronbrink]

Good to know information on and my experiences with the Cielo Breez Max, buried in my Dreiha Atmos 4.4 Home Install thread, got some attention. Thanks @rich.dev for the mention!

Edited July 5 by Ronbrink

[Treasure Coast Vault]

Thanks for posting this Thermostat  @Ronbrink. I would have never found it without your original thread.

Here is the way the Pioneer cycles in the Ollie 2. It is in an A/C space kept at 80 degrees with the Pioneer set to 76 for testing. 

[Ronbrink]

1 hour ago, Treasure Coast Vault said:

Here is the way the Pioneer cycles in the Ollie 2.

It is my understanding that these inverter a/c units are designed for always-on cooling, wherein the fan and compressor run continuously at variable speeds for better dehumidification and energy efficiency. It will be interesting to see any differences noted in normal operation of your unit compared to that when using the Cielo in Comfy Mode. 

Edited July 5 by Ronbrink

[Treasure Coast Vault]

@Ronbrink did you mention there's a way to have the fan continue running for a few minutes after compressor shuts off?

[Ronbrink]

16 minutes ago, Treasure Coast Vault said:

@Ronbrink did you mention there's a way to have the fan continue running for a few minutes after compressor shuts off?

Per the June 2 post in my Dreiha Atmos thread:

“The following has been found beneficial in ‘Setpoint’ selection in Comfy Mode, but may be applicable with use of Comfy Max Mode, as well; TBD. It is important to know that a setpoint one or two degrees below the upper range of temperature selected will have the fan run more than the compressor prior to power shutdown; whereas a setpoint of three or four degrees will have the fan and compressor turn off in sync, and the outside blower fan runs a half minute or so before total shutdown of the unit.”

I have tried it both ways and works as described. 

[CRM]

20 hours ago, Treasure Coast Vault said:

I went ahead and started a thread for this Smart Thermostat. I just installed it for my Pioneer Inverter and it works like a charm. Fan shuts down with the compressor. A wonderful little gadget. Thank you folks for showing us this.

All I did was use the USB port in the Ollie for power and it was a "Breez" to get connected. Thanks for schooling us on the comfort modes too.

 

Thanks for this! I'll be installing a Pioneer myself in the near future and it's good to know that I can use this thermostat with it. 

[Treasure Coast Vault]

@Ronbrink yer a genius. Thank you!