Truma Aqua Go filter failed

[Patriot]

This morning while doing a full systems ‘go’ inspection on Hull #634 XPLOR, I discovered when I configured the Truma water heater valve to the ON position, an impressive stream of water shot directly out of the Truma filter exterior housing. After a little troubleshooting, I removed the filter and discovered that inside the filter housing, a small black round piece of plastic had blown out of the filter housing. This rendered the filter useless. We have had 5.5 years of trouble-free service from our tankless Truma and this was a first. We like our Aqua Go.

I am posting this in the event anyone should have the same issue with their Truma filter. I have the optional antifreeze filter which works in a pinch as a back up. If you do not have the optional antifreeze filter as a back up, you will be stuck like Chuck with no hot water. In order for the Aqua Go to work, it has to have the filter element.

I contacted Oliver Service and ordered a OEM replacement and an extra back filter up of the exact one you see in the below pics. “Two is one and one is none.” 🫡🇺🇸

Replacement filters are $95.00 plus shipping. Thank you Mike Sharpe for getting my new filters shipped out. 

 

The tiny piece of plastic that broke loose. 

Here is the filter that failed. You should not be able to look through your filter. The arrow points to where  this tiny piece blew out. There is no way to repair it. 

I pass this on, so that if you have this issue you can just replace the filter with a new one.

 

Edited 10 hours ago by Patriot

[Galway Girl]

Part number of OEM Filter is 
AquaGo Replacement Filter # 77000-00251

[Rolind]

Thanks I will keep an eye on mine!

 

[DunnYet]

Thanks very much @Patriot for this. It makes me wonder - I generally leave the “heater” filter in all the time regardless of season. Should I pull it for the “off season” and only put it in during the cold camping months? I only switch to the standard filter when running the decalcification cycle. Am I doing this wrong?

[Ollie-Haus]

Thanks for sharing David, I just purchased a backup on Ebay for $25. 
 

If anyone needs a replacement or spare and can’t find one on the cheap, they are available on Amazon as well. 
https://a.co/d/00C38npm

Edited 6 hours ago by Ollie-Haus

[Patriot]

7 hours ago, DunnYet said:

Thanks very much @Patriot for this. It makes me wonder - I generally leave the “heater” filter in all the time regardless of season. Should I pull it for the “off season” and only put it in during the cold camping months? I only switch to the standard filter when running the decalcification cycle. Am I doing this wrong?

@DunnYet 
Open source -
No, you should not leave the Truma winterization (bypass) filter or standard stainless steel filter installed all season long. [1]

If you are actively using your RV during the camping season, you should be using the standard stainless steel filter (or the Truma Electric Antifreeze Kit if actively in use). The official winterization plug/filter is strictly designed to replace the standard filter for winter storage and is not meant to be run full-time. 

Keep these quick winterization rules in mind:

• For Winter Storage: Drain your Truma system and remove the filter cartridge entirely. Store the filter in a dry place inside your RV and leave the yellow Easy Drain Lever closed. Leaving any filter inside during freezing weather can trap water, expand, and permanently damage the unit. [1, 2, 3]
• For Active Winter Camping: If you plan to travel in freezing temperatures, you can use the Truma Electric Antifreeze Kit. This specific kit can be installed in place of your standard filter to keep the water heater from freezing without draining your propane. [1, 2]
• For Normal Summer Use: Remove the winterization plug and reinstall your standard stainless steel mesh filter before de-winterizing and turning your water system on for regular use.

Edited 1 hour ago by Patriot