Leaderboard
Popular Content
Showing content with the highest reputation on 03/27/2017 in all areas
-
Knowledge Base Article for Zamp Solar ZS-30A Charge Controller The Zamp Solar 30 Amp 5 Stage Digital Deluxe Solar Charge Controller # ZS-30A has PWM or Pulse Width Modulation, which is a digital signal that is used to control power applications and has 5 stages of charging for best battery health and longevity. This controller can support and is programmable for the 4 typical types of deep cycle batteries – WET, GEL, AGM and Calcium. We pre-set the controller at the factory according to what batteries are installed. 12 volt solar charging power. LCD screen displays battery voltage, charging current, charging capacity, battery types and faulty codes. LED light indicators show charging status and battery condition. 5 stages of charging: Level 1 – Soft Charge – When batteries suffer an over-discharge, the controller will softly ramp the battery voltage up to 10V. Level 2 – Bulk Charge – Maximum current until batteries rise to Absorption Level. Level 3 – Absorption Charge – Constant voltage charging (battery is over 85%). This stage takes longer than any other stage to complete. You will typically see your battery status remain in this stage unless you are not using the camper. The full battery indicator is about the last 2% and while running lights and other components it will remain in the absorption stage. *Battery volts displayed during this stage are charging volts not actual battery volts. Level 4 – Equalization Charge – Only for WET battery or Calcium battery type. When the battery is deeply drained below 10V, it will automatically run this stage to bring the internal cells to equal states and fully complement the loss of capacity. (Gel and AGM batteries do not run Equalization Charge). Level 5 – Float Charge – Battery is fully charged and maintained at a safe level. Fully charge is more than 13.6V. Includes a port for an optional external battery temperature sensor. Zamp Charge Controller & Digital Monitoring System (Battery Volts) Both systems will display charging volts rather than actual battery volts when power is being supplied to the batteries. Customer interaction The charge controller has 2 buttons. One button labeled Amp/Volts can be used to scroll through relevant information Amp/Volt Button Current battery volts or charging volts Current Amps being supplied to the battery (Initial startup will be lower amps and slowly increase to maximum output depending on sunlight available. Current total of Amp Hours supplied within the 24 hour timeframe. This setting will reset with every 24 hour period. Current Battery Temperature. (Displayed in Celsius). This is used by the charge controller to monitor the battery. Battery Type Button This is pre-set at the factory based on the type of batteries installed and should only be changed if you replace your batteries with a different battery type. Zamp Error Codes: P01 - Solar Panel Reverse Connection P02 - Solar Panel Over Voltage 601 - Battery Disconnected or less than 3.0 Volts 602 - Battery Reverse Connection 603 - Battery Over Voltage (> 17.5 Volts) 604 - Battery Temperature over 65C2 points
-
Hello everybody, My wife (Lucy) and I are life long East Tennesseans. For several years we have discussed getting an RV when we retire. That time is fast approaching. We have looked at a Casita but decided it was not what we wanted. However, we do like the fiberglass construction and were drawn to the Oliver. We also like the fact that they are made less than four hours from our home. There is much to be learned from reading the forums but nothing takes the place of actually seeing one. Sadly, according to the "See an Oliver" page, the closest Legacy Elite II is almost as far away as Hohenwald. If there is anyone in our area that would be willing to let us have a look, we would greatly appreciate it. Bye for now, Oscar1 point
-
Voices and Post Numbers are still there. It's just that now they are the same color as the background so you can't see them except faintly in the slightly darker every other thread line. I'll take up for Larry, if it were not for him and him alone, this forums would not exist - AT ALL. He started it back in 2008. I'm not sure if Oliver knows or understands how important these forums have been to their company's success and it's people like Larry and Betty Harmon that have made it great.1 point
-
I agree, the forum has become/is becoming all but unusable with the slow connection speeds and the seemingly endless changes that pop up unannounced almost daily. So, would the keymaster Id'd as JWalmsley please step forth with a post and explain what your function is. We also need a direct contact cell number for you so we can contact you whenever there is a problem. Since the forum members generally consider this a 24/7 job, it would probably be wise to include your usual bedtime so we'd have an idea when it would be too late to call you.1 point
-
Recent Achievements
