Loading Water in Boondock Mode

[HDRider]

It loaded about 1 gallon, but would not load more.

 

Can someone suggest troubleshooting steps?

 

The pump is running and the valves are properly set.

 

Thanks

[Galway Girl]

I assume you are trying to fill your fresh tank from a "container" using your rear boondocking port to suck in water through the on board pump.

Q) Was the pump able to pump any water out of your tank before you started? It may have lost prime.
If you lose prime you can often get it to reprime by either removing and checking the water filter (near the pump) or by opening and closing each of the valves and ending back on the boon docking configuration.

Our 2019 Has this Valve Configuration...not sure if it's the same for you but just as a cross check for sucking in thru our rear port.

Edited 3 hours ago by Galway Girl

[Steph and Dud B]

How long is the hose you're using to the container? It works best with a short piece of hose.

[jd1923]

2 hours ago, Galway Girl said:

Was the pump able to pump any water out of your tank before you started? It may have lost prime. If you lose prime...

I've pumped from our 35-gal aux tank in the truck about 30 times. Only once it would not pump. My son was using the Oliver and he's new with RV stuff. He kept trying the water. Normally, when we here a first gurgle from the pump, we stop and refill the tank. Yes, when you loose prime, water will not pump regardless of the valve configuration.

To fill water that one time, we had to tow to use a pressurized hose. I filled the FWT, then primed from the boondocking port and finally attached the hose to the City Water inlet to prime all faucets, the HWH and toilet. I wanted everything full!

Also, we pump often when the truck is attached or at a distance, so I connect the 10 ft plus 25 ft hoses we carry, from truck bed to boondock port. Length of hose has not mattered in our case. However, OTT installs a basic water pump which we replaced with a REMCO US-made variable speed pump, with a little PSI and GPM bump over th OEM pump. 😎