Leaderboard

The way the system works is if you are not logged in and have not been logged in for the past 1 hour. Then receive a private message, it then emails you that you have a message waiting. But if you are logged in or show in the active user list for the past 1 hour, it will not send a notification email. Hope this clears things up a bit! Thanks!

You can probably unscrew it they will come out and try to clean it out or take it up to the auto parts store and buy a package of a few replacement ones and crew in a new one. They will have them straight as the ones that came on the suspension kit or you can also get some that are at a 45 degree for easier use for some areas. The reason I said to take it up as they cmd in different sizes. Good luck Gary

For a 'plugged' grease fitting I usually try the following: clean the fitting and the immediate area around it. Then we spray P B Blaster and wait a few minutes. Then try to grease. If it still doesn't work we warm the fitting with a heat gun on low (a hair dryer probably would work too). That should warm the old grease enough to allow new to enter. Last resort is to screw in a new fitting. A pain sometimes, but better than not getting grease in there. How much grease did all 16 (15) take?

Apologies for not replying earlier. My password was corrupted and it has been difficult to re-set it Regarding vendors, below are the ones we have invited. To date, we have had only two to respond that they were unable to attend. Those two are either working on sending a replacement or providing a static information center and documents. Truman Dexter Dometic Progressive Industries Zamp Andersen Micro air Furion Trojan FYI the weather for Lake Guntersville looks terrific High in the upper 70s and only a 20% chance of rain !! Coy

Your EMS (surge protector) is probably seeing the generator as a open ground. Look at the display and see if there is a error code. You will need to turn off the EMS at the display under the left side bed in order for the power to pass to the trailer. You will need to get a netural to ground bonding plug and plug into the generator to correct the problem to use the EMS with the generator. Of course bypassing the EMS will leave you unprotected from low or over voltage problems should you have them. https://www.makariosrv.com/generator-plug-bonded-progressive-industries-generator-plug/