Jump to content

Recommended Posts

travel trailer units for sale
Find Oliver Travel Trailers for Sale
New Travel Trailers for Sale

Did the handle pull in and out easy? If not, this might be a good time to lubricate the cable. Spray some silicone lube or graphite on the cable, before putting it back and tightening up on the attachment. (That whole valve is replaceable as a last resort, but it is more fun if the tank is empty). If the tank is full, this means it was the main dump valve. This valve is located under the left (street side) bunk or cushion, at the back of the camper. Make sure the cable is not kinked. We have seen this happen to SOB (some other brands) and usually, again usually, they are easily fixable...

 

 

 

 

 

 

Link to comment
Share on other sites

The pic shows the black valve but the grey valve is the same. You can pull up on the pin pictured to dump the tank with a pair of pliers or grab the plastic cable cover with your hand out at the dump valve compartment and pull the handle while letting the wire slide thru the cable to open the valve. Then just hold the cable cover again to close it :)

IMG_20170924_060433.thumb.jpg.550e877736380e05ba6c80215286bffc.jpg

  • Thanks 1

Happy Camping,


null


Reed & Karen Lukens with Riffles our Miniature Poodle


2017 Oliver Legacy Elite II  Standard, Hull #200 / 2017 Silverado High Country 1500 Short Bed 4x4


Past TV - 2012 Mercedes-Benz ML350 4Matic BlueTEC Diesel


Click on our avatar pic above to find the videos on our Oliver Legacy Elite II


 

Link to comment
Share on other sites

The tee handles are held onto the threaded part of the inner cable by a single 1/6" steel roll pin. The lock nut does not really have any function. My black tank pin sheared off, which is really wierd because I do not ever use it. Maybe it was damaged at the factory? No, that could never happen, LOL..... I plan to (carefully) drive out the pins on both handles and replace them with stainless steel cotter pins.

 

Something to check while you are messing around with yours....

 

I would have thought the handles would thread onto the inner cables, it would be a more secure setup.

 

John Davies

 

Spokane WS

 

!

SOLD 07/23 "Mouse":  2017 Legacy Elite II Two Beds, Hull Number 218, See my HOW TO threads: 

Tow Vehicle: 2013 Land Cruiser 200, 32” LT tires, airbags, Safari snorkel, Maggiolina Grand Tour 360 Carbon RTT.

Link to comment
Share on other sites

The roll pin on the handle in the bathroom broke, I found replacement handle at campground store .   Handle screwed on to treaded end of cable,  no pin to brake...   I plan to replace other two handles...   Note ; The nut tightens to lock screew-on  handle.

Link to comment
Share on other sites

The roll pin on the handle in the bathroom broke, I found replacement handle at campground store . Handle screwed on to treaded end of cable, no pin to brake… I plan to replace other two handles… Note ; The nut tightens to lock screew-on handle.

Can you please post a source or make and part number of the handle?

 

thanks

 

John Davies

 

Spokane WA

SOLD 07/23 "Mouse":  2017 Legacy Elite II Two Beds, Hull Number 218, See my HOW TO threads: 

Tow Vehicle: 2013 Land Cruiser 200, 32” LT tires, airbags, Safari snorkel, Maggiolina Grand Tour 360 Carbon RTT.

Link to comment
Share on other sites

  • Moderator+

You can open the valve manually to dump the tank, but probably, the cable only slipped out of the valve, it is secured with a set screw.  Be careful trying to remove the roll pins, I broke a handle years ago on the OOI trying to do just that.  The cable will slide completely out of the housing if you want to lubricate it.

Steve, Tali and our dog Rocky plus our beloved Storm, Lucy, Maggie and Reacher (all waiting at the Rainbow Bridge)

2008 Legacy Elite I - Outlaw Oliver, Hull #026 | 2014 Legacy Elite II - Outlaw Oliver, Hull #050 | 2022 Silverado High Country 3500HD SRW Diesel 4x4 

 

             801469912_StatesVisitedTaliandSteve08-23-2021-I.jpg.26814499292ab76ee55b889b69ad3ef0.jpg1226003278_StatesVisitedTaliandSteve08-23-2021-H.jpg.dc46129cb4967a7fd2531b16699e9e45.jpg

 

 

Link to comment
Share on other sites

  • 2 weeks later...

A (belated) THANK YOU to all who gave input!  It was a thrill when we manually emptied the grey tank - which we've been doing ever since!  The set screw will hold the cable in again one day, but for now, the routine is perfect.  Again, thank you.  :)

  • Thanks 2
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...