Jump to content

Nan

Member+
  • Posts

    277
  • Joined

  • Last visited

Everything posted by Nan

  1. Horace and Dianne, we are planning on picking up a 1995 BMW motor (for grandson) in Upper Marboro, Maryland...so guess it is not Maryland after all. LOL. Since I live outside of Savannah, Ga., this will be a long trip.
  2. I am in the market for this. Can someone please tell me what they have and the pros and cons for their brand and model..or just tell me what to buy? Thanks so much.
  3. Thanks, Sherry. Had a little set back so hopefully in a couple of weeks I'll be ready to go camping to Virginia!!!!
  4. Thanks. The Oliver was only used for about 1200 miles before I bought it late last year. I have not been able to take it out due to knee and hip surgery. I am hoping that will change this coming Saturday. I only have a grey and fresh water tank to contend with as I have a composting toilet.
  5. Thanks again Mike. I will try that too.
  6. Thanks Mike. I will try draining it on a slope the next time I go over there. What about trying to fill it up and the water comes up in the bathroom floor and the sink in the kitchen and the monitor says it is only 69% filled?
  7. There are a few questions that I came up with today while sanitizing the gray and fresh water tanks. First, after about 20 or so minutes of running both sinks (Trying to fill up the gray tank), The shower and sink start to fill up regardless of is the shower trap is open or closed. Does this mean that it is full? If so, the gray tank monitor says that is is only 69% filled. Next, after draining the tank with the slinky looking holder with no high points and with the camper completely level, the level reads 38%. Is this a level sensor problem? If so, can it be replaced and where is it? Theres nothing in the black tank, so it reads 0% and the fresh water drained to about 9% and filled up to 100% on the monitor so I don't thing it's the monitor itself. Thanks, Nan.
  8. Thanks everyone! I really appreciate your time.
  9. Would someone please measure their dinette cushions and give me the size? I have to have some made and I have given the measurements of 25x25x4 to the upholstery people. Thank you so much. Nan 2017 Elite II Hull 267
  10. I am following this, BuckandConnie because I do not know either.
  11. Thanks Mike. I have a new anode and a toothbrush wire brush. All I need is WD 40. I honestly don't think the previous owner had a clue about these problems. She had a new heater and air conditioner installed trying to rid the Oliver of all of the fiberglass that was left in the ducts. It is obvious she never turned on the heater (because it would not have come on) and she had no clue to not leave the anode out of the water heater. She had only pulled the Oliver about 1600 miles when she sold it to me. So, I am certainly not faulting her. This is all a learning curve for me and it has been a little confusing because I don't have an Oliver tech walking me through it. But, thanks to people on this forum, I am getting closer to being able to go on the road.
  12. Thanks Mike. This is the way the camper came from the previous owner. I am really beginning to wish I had bought a new Oliver.
  13. When the Oliver was winterized the anode was removed and laid in the water heater. Today we un-winterized the Oliver and screwed the anode in and it leaked. We pulled it and taped the threads and it leaked again. The housing that hold the anode is very rusty. Tried to clean it out, but still leaked. Can this be replaced without replacing the entire water heater? Also the On/Off switch in the water heater is frozen in the On position (that is why the fuze was pulled when the hot water was drained.) What should I do? Thanks again everyone. 2017 Hull 267
  14. Do you think a 120# old woman could put your Clam up and take it down by herself?? Thanks.
  15. Thanks for commenting Sherry. You helped me out a lot. Yep, even the service guy had not seen the Bluetooth one and he a service tech for them. I was a little worried about him because I had not heard from him in a couple of weeks (after he received the board), but found out his wife went into premature labor and that stopped his world. Anyway, like I said, if anyone needs a new thermostat please just let me know. I will send it to you free of charge.
  16. He added a wire, but I am totally ignorant about any of this, so I will ask him about that wire. And there is that add on fuse that is behind the breaker panel above the nite stand that he found. I do not know what that is for either. All of this happened because the prior owner wanted all of the fiberglass out of the ducks because of her allergies. But, I do not understand why she replaced the brand new Oliver installed air conditioner and heater. I have the paperwork that shows who and when it was done. I am glad this has been resolved because it has been a trip. I now have a perfectly good thermostat that I will send to anyone that needs it.
  17. Finally had the heater repaired. The tech said that it was wired wrong and that since it had power going to it all the time the main board burned up. He installed a new board and replaced the fuse and all is working just fine. Thanks everyone for helping me with this.
  18. Thank you so much!! I ordered it!!! Nan
  19. Can someone please tell me what gas hose will fit on a Blackstone 17" grill and a 2017 Oliver II? I have two connectors on the Oliver and I want to be able to use them with the Blackstone grill. Thanks so much. Nan Wallace hull #267
  20. John, if you could make a list of a maintenance schedule (what and how often), I would greatly appreciate it. Thank you, Nan
  21. And it was. And I told the tech that too. It cost me $451 today.
×
×
  • Create New...