Jump to content

Leaderboard

Popular Content

Showing content with the highest reputation on 07/30/2026 in all areas

  1. Ok, so those settings may have been incorrect, but that's not causing a breaker trip. There's still something else going on. Can you run a heavy extension cord (12 gauge) from an outlet in your garage directly to the plug/cord on your microwave? (Don't use a cheap cord, it could melt.) If the microwave works that way, there's a problem in your trailer, either a wiring fault or a bad breaker in the Xantrex. If the microwave trips your garage breaker, there's a problem with the microwave and it should be replaced.
    1 point
  2. I know this will be hard for many to understand and/or believe. But if you are camping in our northern Wisconsin State Forest/State Parks you will note that most of the campsite leave a fair amount of gear outside at the campsite at night and when elsewhere without fear of someone taking something. It is just that way in this part of the world; really it is the rural upper Midwest. I have been camping for over six decades and have never lost an item.
    1 point
  3. I'm thinking you mean the GCFI 20A outlet you are plugged into had tripped. Your EMS readout displayed 12A which is the total input amperage from shore power, which would include the Xantrex charger if it was in fact charging at the time. Sounds like a temperamental GFCI to me and it's not the first time I've read this story on our Forum! Glad our home was built in 1980 when only bathrooms had GFCI outIets. If it was my garage or exterior outlet that I used for shore power, I would replace it with a standard 20A outlet, regardless of code. Or add a new 30A breaker to your service panel, run wire and a 30A dedicated outlet for shore power. This is what I did where we park our Oliver. Not running on the 2KW Xantrex? Check and lower your shut-off voltage setting which is often the case with Xantrex inverters (not Victron). Your oven pulling only 11A (12A - 1A) should run on any 15A household circuit, let alone 20A. And 11A on 120VAC is equivalent to 110A on 12VDC which translates to 1320W, which again should run on a 2000W inverter with a lot or room to spare! Could the oven be defective? Not likely, since it started up and pulled a measurement read by the EMS. You could think it's the oven since it blew on two power sources. But the microwave works. The oven must create a power spike the GCFI protection doesn't like. The only way to be sure is to connect to a shore power source that is not GFCI! The 30A shore power outlet at any campground are not GFCI outlets. Next time I need a GCFI outlet is the next time I take a shower with a live blow dryer in hand! 🤣
    1 point
  4. We’ve got the manual door lock, too. It’s one of those things (like the suburban hot water tank) that is simple and reliable. One less thing to worry about when you are way out “there”. Mike
    1 point
  5. We’ve had good luck with RVLock support - as they are responsive and quick to send out parts under warranty. I forget the exact failure mode, but our original OTT installed RCLock quit working. After chatting g with them on the phone they mailed out a replacement circuit board for the cost of shipping. (I’d whine about having to pay shipping - but I’ll get over it.) In the meantime, I had purchased a whole new unit from Amazon. This one talks yo you and had a lock/unlock sound that doesn’t wake the neighbors. I replaced the circuit board in the original lock and kept it as a spare. Last season, the “new” lock stopped unlocking reliably - only withdrawing the deadbolt about halfway and requiring a second attempt to get in to the trailer. So, the “spare” gets re-installed. Several more emails and sending them a video of the lick not working and they say they’re sending me something. Not sure what yet. I still don’t care for the battery situation. Trying to install 2 rows of 2 AA batteries stacked vertically and getting the battery cover on takes dexterity and fast hands.
    1 point
  6. We also had a great experience with RVLock last year when we replaced the keypad with the upgraded version (the numbers were peeling off on the original pad). After commenting this story to the RVLock folks manning their booth at the RV show in Quartzite last month - I was awarded with a huge swag bag of cool stuff! A great and responsive company, RVLock.
    1 point
  • Recent Achievements

    • Haoleboyk earned a badge
      First Post
    • pfin3 earned a badge
      Week One Done
    • Steph and Dud B went up a rank
      Grand Master
    • NDKoltz earned a badge
      Week One Done
    • RV Newbie earned a badge
      One Year In
    • Grizz000 went up a rank
      Apprentice
    • Sandman went up a rank
      Apprentice
    • Sandman earned a badge
      Collaborator
    • David Carter earned a badge
      One Year In
    • FirstApex earned a badge
      One Month Later
    • tbudy earned a badge
      Conversation Starter
    • carpenter earned a badge
      One Month Later
    • fvineyard earned a badge
      One Month Later
    • Doug Morring earned a badge
      One Month Later
    • HDRider earned a badge
      Posting Machine
    • TK Oliver earned a badge
      One Month Later
    • JimNECrickett earned a badge
      One Year In
    • srthomsen earned a badge
      Very Popular
    • fvineyard earned a badge
      Week One Done
    • Doug Morring earned a badge
      Dedicated
×
×
  • Create New...

Important Information