HDRider

Unbroken side

Has anyone else broke the tip off the freezer door? How did you fix it?

It was a dirt dauber nest. Got on the trailer, took off the top of the AC, cleaned the nest and all is good with world. I am now sitting in my campsite with a happy wife. It is hard to see how the little bugger got in there it is very well sealed, but he did.

I turned it to fan mode and the growl goes away. I put it into AC mode and the growl comes back. I'd say that is the compressor making the noise. The whole trailer shudders as the compressor winds down. Help!

Just checked on it and the growl is back. I turned it on again and sat there for awhile. The growl came back when the compressor kicked on (I guess that is what kicked on). It seems to be cooling. You could feel a vibration through out the trailer matching the growl when the growl noise came back.

I am getting ready for a trip tomorrow. I turned on the AC and it made a load growling sound but appeared to run normally otherwise. I let it run about 10 minutes and then turned it off. I turned it back on and it sounded normal. Is this something anyone else has experienced with the Truma AC?

We put Calgon and Pine-Sol in our black tank. Mix 40 ounces of Pine-Sol with enough water to just about fill a gallon jug. Top off with a half cup of Calgon Bath Beads. Use eight ounces in each tank (or more in especially hot weather or if your tanks will be filling up slowly over time).

Mike just sent me this. Great pic. Not sure what manual that is in. I could not find it.

I hit these on both sides. What did I miss?

This forum, and you sir, rock. I had called Oliver service after hearing such a noise. I never heard back from them and forgot about it until I read this. I was hearing the "creaks and pops". I just lubed the 12 zerks. Thanks so much

Welcome - Travel far, travel wide, and travel safe.

Does Oliver have a process for buying parts?

That would be a game changer

This makes me feel good. Thanks

The service department will coordinate with parts for you, or at least they did in the past. Call Service, or better yet, use their chat it seems to work better by opening a ticket.

Welcome back. Sounds like you are running and gunning. You should have no problem finding a used Ollie. There seems to be a lot of folks letting them go.

Your comment prompted me to go take another look at the fridge light. My light and thermostat seem to be one unit with a wire going into the interior of the fridge. I do not see a way of pulling the plug on the light. Can you illuminate on how you disconnect the light.

I was under the impression adjustments were being considered by Oliver management. Have they announced the end of service at the factory full stop?

Yes. Jeff Coleman NE Arkansas LE II Hull 1423 I'd like to see us start a dealer service rating system also. I have one near me everyone should steer clear of. Do we have anyone here with web programming skills that might platform these?

I take the bulb out. Then this happened.

Nope

The screw in my faceplate fell out and left home. Two questions 1) Would a Home Depot carry a screw like this? 2) What would be a good glue to use on the screw to hold it in place? I am told not to use Loctite. I need a tiny bit larger thread. The screw is not biting into the fiberglass. The hole is wallowed out.

Nice

Just thought it would be a good place to carry a cooler. Not a need, simply a want