mossemi

It was on hull 193. Mine is located high and in back of the refrigerator. It is accessible through the upper exterior refrigerator vent. The power switch is on the main panel in the foyer. And in a pinch you can remove the upper vent panel for some convection cooling. Mossey

I have to admit that I can’t reach anything over the side of my F150, but they did put a ladder in the tailgate for this old man! Of course the tailgate ladder is pretty much unusable when hooked up to the Ollie. Now both of the 1980 VW Rabbit diesel pickups I owned were a breeze to reach anything in the bed from the sides or the tailgate.😁 Mossey

The picture shows the breaker panel mounted to the front of the panel for easy access. Mossey

That’s the way they are manufactured. I believe that John Davies has a post in his how to library explaining his rework of the left swing door on the Progressive Dynamics power control panel. Our LE2 has a breaker marked Blower in the attic that controls the power to both the MaxxAir and Ventline fans. Mossey

The picture of the wiring diagram I posted above is from the 2018 Elite 1 manual and it indicates the the WP fuse is 15 amps, not 20. @rideandfly's pictures appears to be from an LE2, but it does show that the WP uses a 15 amp fuse, which is blue. Mossey

If your pump is still not working after verifying the fuse condition, check the wiring around the pump. There have been multiple instances of wiring failures near the pump. And I personally found a female spade connector had fallen of the pump switch in the bathroom, disabling the pump. Be sure that there are 3 wires connected to each to each switch. The picture below show the water pump wiring originating in the converter which also houses the fuse panel. There are AC and DC fuses in the panel and the picture indicates the water pump fuse is rated at 15 amps. Mossey

I had a similar problem with a 6 pack of tablets that I had for couple of years. It seemed as if the had swollen up and they were also a little more likely to crumble. I just threw them away and the newer package worked fine. So my take away was to only buy them when needed. Mossey

Are your water supply valves under the curbside bed in the correct positions? Do you have cold water at the outside shower while connected to the City water inlet? Mossey The following is from the OTT LEII owners manual.

Thanks for pointing that out! I assume that’s to prevent alternator charging. Mossey

I am amazed at your connectivity to the internet in such remote locales. You may have mentioned it or I missed it, are you using Starlink for communications? Mossey

I believe that if you insert an ATC fuse into the trailer side of the 7 pin connector between socket 3 and 4, it will send power to the running lights. So I was pondering the possibility of that also supplying power to the awning. Mossey

I would open a service ticket! But it seems like a pretty good safety feature. Mossey

Happy and Safe 4th to all! Mossey

And A Happy 4th to y’all as well. Glad the Platinum Package is all you hoped for! Mossey

I usually start with a plastic razor blade or scraper. I've had success with De-Solv-It, Goo Gone or Goof Off on a coarse rag. And don’t kill yourself because mine seems to come back a little less each time I clean the edges. Mossey

Welcome to the forum and good luck on your shakedown trip! Mossey

Welcome to the forum! What type of batteries do you have and how many? How are you reading the battery voltage? What is the unloaded battery voltage at rest or about 15 minutes after you have remove it from shore power and without any DC loads drawing the battery down? If you only run the inverter for a short time, like reheating your coffee, what is the voltage after you turn the inverter off? More information included with a question = better answers. Mossey

As do I, but I do have a Micro-Air EasyStart installed on my Dometic air conditioner. @Steve Morris Do you have the Truma air conditioner? If so, what is the starting amperage draw? Have you tried the air conditioner on a 20A circuit? Mossey

Correction! Saw this Champion 2500 on Amazon yesterday at $414 and today it’s at $399. I have found the reason for the price change, it’s a different generator. The generator priced at $414 is dual fuel and the one priced at $399 is gas only. Sorry for the misleading post! Gasoline only. https://www.amazon.com/Champion-Power-Equipment-200961-Ultralight/dp/B08L47G374/ref=sr_1_3?crid=2UTQ1DDM03KCO&keywords=Champion%2B2500%2Bwatt%2Bgenerator&qid=1688037717&sprefix=champion%2B2500%2Bwatt%2Bgenerator%2B%2Caps%2C101&sr=8-3&th=1 The dual fuel model is here. https://www.amazon.com/Champion-Power-Equipment-200961-Ultralight/dp/B08L45W2V9/ref=sr_1_3?crid=2UTQ1DDM03KCO&keywords=Champion+2500+watt+generator&qid=1688037717&sprefix=champion+2500+watt+generator+%2Caps%2C101&sr=8-3 Mossey

Very nice mod! That's an excellent arrangement for y’all. Mossey

https://youtu.be/M-bTLdMjuqU This YouTube link should provide enough information about bonding the output of a un-bonded generator to satisfy your curiosity. Mossey

Galway Girl and Craig are traveling to Alaska so they may not have great communications. Be patient while waiting for a response. I'm not going pretend that I am familiar with this modification, but it does look like there is a support bar that also connects the 2 regulators. He also mentioned the adapter the gas flows through must stay on the large regulator and it does look like a wrench is needed to hold the adapter while you turn the small regulator. Mossey

You are correct, Victron does not communicate with Xantrex. I will stick with the Xantrex until it quits. Then I will try to figure out where to place a MultiPlus-2. Mossey

I chose Mopeka because they are supported by Victron's software and interface easily with their GX family of products. The pictures I shared above are taken from Victron's VRM product servers which are located around the world. This also gives me the ability to receive email or text alerts such as a low SOC reading from my batteries. Mossey

I use it with a 2000 w Xantrex. I’ll install a MultiPlus II when the Xantrex fails. Mossey