rich.dev

Thanks @MAX Burner, never been but I’ve been preparing/watching Quartzsite/LTVA videos for few years now! Will be there next year after I've retired, hopefully will see lots of Ollies around then!

Nice, how did you do the hard reset?

Jason, and you did not have issues with the flame blowing out? That is a huge concern for me, that the flame would blow out from the air passing by while doing 60-65mph going down the highway, and if it doesn't relight, well now you have gas just blowing out! Unless there's a safety feature that will shut the gas off if the flame bows out, I don't know!

Personally, I would not run the water heater on eco or comfort while driving….that mode requires propane and a flame! For driving, with the antifreeze kit on, turn off the propane and set the truma to antifreeze mode, that will keep it from freezing while on the road without having to leave the propane on.

I believe this video should answer your questions!

Yah saw that video, I thought he did an ok job, he missed a few important features of the Oliver, ie boondocking port, area under the street side bed where all the valves are (how nicely it’s all laid out), dual pane windows. Maybe he was just pressed for time!

My delivery date was spot on!😁

Welcome from a fellow ex Airstream owner. We absolutely love our LEII twin bed! Not knocking Airstream, it’s still a good trailer, but Oliver‘s quality is far superior!

approx. 300lbs....my 2500HD has a payload/cargo capacity of 3658lbs

@Vector - Lanham I'm getting the Cargo Ease Commercial 1500 bed slide. 1500lbs is probably overkill, but hey why not!

for those who haven’t seen the posts referenced by @Ronbrink, here you go!😊

My LEII hull#1386 doesn’t have tank heaters! Pretty sure only some older Ollies have tank heaters, back in the day when Oliver still entertained modification request from owners.

I was just stating what Oliver recommended to me when I picked up my Oliver, i.e. leave the inverter off (on the inverter) and use the remote to turn it on/off when required.

Yes leave the on/off button on the inverter in the off position, use the button on the remote/panel to turn the inverter on or off.

Should work, plusnut is another option. The flange on a rivnut is fairly small, a pre-bulb plusnut expands significantly more than a rivnut when compressed. And plusnuts are not as critical with the hole diameter as rivnuts, so a great option for fibreglass I think.

@Brian and Brandelyne I’m ready to order this UWS 34 box, however, I see they are available in 2 heights, one is 22 inches and the low profile (LP) is 13 inches, which one do you have?

Before you replace it make sure the hex nut inside is not loose! Check out this thread

Ah, good to know thanks, I would've "forgotten" as well! 😜

Yup that’s what I have as well

Nicely done @Ronbrink! I also have 2 gasstops just waiting for me to be installed! I read somewhere that the gas stops can cause gas flow issues with the truma water heater or heater, can’t remember which one, do you have the truma water heater and heater, if yes any issues?

@DonnaDuane here is a list of the EMS codes, looks like open ground! this box should be under your rear dinette. Check out this thread, sounds like (might be) your ground bonding plug is faulty, so either get a replacement neutral ground bonding plug, or turn off the EMS and trust the generator. IF it’s a faulty ground bonding plug, a replacement bonding plug is not that expensive, that would be my go to. Stupid question, did you check if the ground bonding plug is seated properly in your generator?

Great thanks....we take delivery of our new 2024 Chev Silverado 2500 6.6L with 3658lbs payload on Saturday, a cap will follow shortly and a slide. Also, considering Line-X bed liner spray but not sure if really necessity with the cap.

@ScubaRx it's been a few years but do you still have the same bed slide, any pictures?

2 filters if you have the antifreeze kit. The original filter is used to decalcify the unit.

My trailer is in storage but I’m pretty sure it’s 4/0 AWG cable. Maybe this question was meant for someone else, I still have the Xantrex?