Leaderboard

The views of our customers are of paramount importance to Oliver Travel Trailers. We will always strive to provide the best possible customer service and to identify and address all legitimate questions and concerns relating to our products or services. Oliver Travel Trailers values its customers points of view as a part of the “Oliver Family”. The Camco 40055 Brass Water Pressure Regulator is by its nature a flow restriction device as most pressure regulators work in this manner. Any water pressure regulator may be subject to failure. Failures are normally caused by a manufacturing or mechanical defect or physical damage. The Camco model 40055 has a preset water pressure (between 40-50 PSI) on the outflow side. This protects the camper’s plumbing from high water pressure that may be present at the supply and which would cause damage to the trailer’s plumbing system if left unregulated. This water pressure regulator is designed to ensure a safe pressure on the inside of the camper even when there is no flow but this device does not equalize to the higher pressure when no flow is present. Camco and other manufacturers make other water pressure regulators that are adjustable in nature and have a pressure gauge built onto the body of the regulator. Both fixed and adjustable pressure regulators perform the same function in broadly the same manner but one is adjustable and can have a visual reference to the reduced water pressure. Personal preference may dictate which one any particular customer may ultimately find preferable, but both do safely perform the pressure regulation function. In an effort to reinsure confidence of the 40055, we selected a random sample of three pressure regulators from inventory and subjected them to testing. The test method employed was a water pressure test with a supply pressure of 100 PSI produced buy our water pressure testing equipment. (All campers are subjected to an 80 PSI pressure test of the water lines as mandated in the RVIA Testing Regulations). A water pressure gauge was attached to the low pressure side of the regulator with water in the valve, 100 PSI of water pressure was applied at the inlet, the outlet recorded a pressure of 44 PSI, +or- 2 PSI on all three valves tested. This method of testing simulated a zero flow and did not result in an equalization of pressure to the higher inlet pressure. Furthermore when the 100PSI was disconnected from the inlet, the valve maintained the 44 PSI on the low pressure side until the pressure was relieved by removing the gauge (similar to opening a faucet). The observed testing appears to support the premise that the pressure regulator Camco 40055: Regulates incoming high water pressure and regulates it down to the stated safe pressure range of the regulator (40-50 PSI). There is no equalization of pressure between the two sides of the regulator under water present but no flow conditions. When high pressure source is removed, the lower pressure is maintained on the low pressure side of the valve until relieved by such things as the operation of a faucet. Our tests indicate that the Camco 40055 water pressure regulator performs its required function of reducing water pressure. As previously stated, this valve does not give the ability to adjust water pressure or give a visual representation of pressure, which may be the preference for some and a matter of personal choice. The manufacturers of the Camco 40055 water pressure regulator are happy to discuss any concerns that may arise in respect of any of their products. They can be contacted by phone at: 1-800-334-2004 or by email at: info@camco.net

1. Always turn Propane tank valve on VERY SLOWLY, otherwise the force of rushing gas can cause safety valves on furnace, frig, or hot water heater to shut that appliance down. Only remedy is shot of gas, reset appliance, then turn gas valve VERY SLOWLY. Seemingly faulty appliance has always worked after that. 2. Always lock bathroom door before driving even the shortest distance. Otherwise it will be broken for sure from swinging open. 3. Never camp between other RVs that run generators with exhaust pointed towards your Ollie. The CO detector will go off. NEVER ignore your CO DETECTOR!!! You might die in your sleep. 4. Never run propane appliances while driving. They can cause gas explosions at gas stations. 5. Viair Air Compressor makes winterizing water lines and keeping tires at proper pressure a piece of cake 6. Anderson Leveling wedge is worthless on ice and snow. They need a studded version. 7. Boondocking in Winter requires a decent and quiet generator. Solar power is gone for perhaps weeks. I recommend the Honda 2200i. 8. Protect front lower sections of shell from rock chips with plastic coating. Tow vehicle will spray a ton of gravel into it, especially in Winter. The folks who applied 3m film to my Audi are doing my Ollie. 9. Keep Drain hose attached to outlet in rear bumper and simply cap the end. This is way easier and cleaner than taking it apart each drain cycle. And always drain Black then Gray for odorless hose 10. Dehumidifier is a must when Winter camping. Otherwise condensation runs amuck everywhere. 11. Hoppy Rearview Mirror Level on front of Ollie saves tons of time. And, your head doesn’t get nearly as wet running in and out and in and out etc, etc in the rain and snow to get the darn trailer level. 12. Use other Ollie owners for tips and advice, especially for Set Up and Departure Checklists. They are valuable beyond belief. I’ll add more as they happen. Happy travels

Here are links to Mike's stuff mentioned above. https://www.amazon.com/Goof-Off-FG653-Professional-Strength/dp/B002MPPYYS/ref=sr_1_3?crid=MR0VA9XT6HW5&keywords=goof+off+pro+strength+remover&qid=1551198148&s=gateway&sprefix=goof+%2Caps%2C176&sr=8-3 and https://www.amazon.com/Ehdis-Visibility-Plastic-Scraping-Windshields/dp/B01HLWB0BM/ref=sr_1_17?crid=MR0VA9XT6HW5&keywords=goof+off+pro+strength+remover&qid=1551198317&s=gateway&sprefix=goof+%2Caps%2C176&sr=8-17 Bill

Welcome Granitestaters! And now that dreaded long wait really begins. But, you will have your Oliver for the full summer season and be old pros with it in no time at all. I just received an email from a friend of mine in upstart New York who told me that he is looking forward to minus 11 degrees tonight after receiving 7 inches of snow last night. Hopefully it is not that bad where you guys are located. In any case, it is time to start that process of gathering the things you want to make that Oliver all your own. Bill

Hello neighbors, there aren't many of us up here yet, but I'm across the river in Bradford, Vermont and pick up my new Oliver Elite in two weeks. I didn't do the factory tour but spent time with an Oliver owner in northern Vermont. Would love to hear of your experiences as they unfold.

Welcome Granitestaters - Glad to have you part of the Oliver family. There are many threads on tow vehicles, a simple search will get you the latest. There are many opinions on the subject, all depends on what you are looking for in a TV. With a clean slate, (and a large pocket book) you have a vast selection to choose from. The folks on this site have a good amount of real world experience and I'm sure will steer you in the right direction. RB

I use GOOF OFF, Pro Strength. It’s available at Home Depot and lots of other places. If the tree sap has crystallized, I soften it with the GOOF OFF and remove the bulk of the sap with a plastic razor blade and finish the removal with more GOOF OFF. Good luck!

I hate drippy trees, cottonwoods are also really bad.... here is what I use. https://www.amazon.com/3M-General-Purpose-Adhesive-Cleaner/dp/B00ZIM9XPI It works very well on sap, bugs and road tar too. It will completely strip any wax so you must reapply a protective coating afterwards. It is quite expensive online but if you call a local auto paint supply store you will find it way cheaper. I pay $14 per quart locally. It is used everywhere for paint prep at body shops. Wear gloves and use adequate ventilation. You only need a quart unless you plan on camping under drippy trees all the time. It is safe for the solar panel and all plastics. I also suggest that you strip off any old wax from the entire trailer hull by washing with a strong solution of blue Dawn detergent and this product. Apply Rejex or a similar non-wax coating. Rejex cannot be applied over wax, it needs to bond to the gelcoat. It will make future cleaning much easier and the trailer will look stunning. John Davies Spokane WA

Is this it, Skalywag? Thanks for the info. Sherry

I financed with Bank of the Ozarks working with Anita and is was painless. A 10,000 dollar deposit at signing the order to proceed, and Oliver worked with the bank and all i needed to do was on the day of pickup sign the bank documents that Oliver had ready for signature and the bank paid Oliver directly. We got a 20 year loan which is like a home loan and the interest paid is tax deductible.

Justin - Yes, a litter box should fit in the area you mentioned. I generally keep a closed storage bin there with cleaning, waxing, etc. supplies when I'm on a long trip. If I'm traveling solo I often keep the bathroom door open (while camped) to aid in ventilation while I'm gone for the day out fishing and hiking (the bathroom vent is left open and the MaxAir fan left on automatic. When traveling with my wife or fishing buddy that open door limits easy usage of the dinette seat closest to the bath. Bill